Energy UNITS FOR LIFT TABLE

Power UNITS FOR LIFT TABLE one
Common Description
This energy unit is designed exclusively to the smaller lift table,Consisting of large pressure gear pump, AC motor, multi-functional manifold, valves, tank, etc. This power unit has been widely made use of in the industry of logistic gadgets which include minifork lift, scissors lift and ariel doing work platforms. The lower-ing movement is controlled by the solenoid valve together with the pace controlled from the adjustable needle valve.
Energy UNITS FOR LIFT TABLE 2
Standard Description
This energy unit is developed exclusively for your medium lift table, Consisting of very effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering movement is actived through the solenoid valve as well as pace managed through the adjustable needle valve. When the lift rises to a substantial positoin, but the electrical power supply is reduce, the lowering movement is controlled from the manual override perform.
Energy UNITS FOR LIFT TABLE three
Basic Description
This electrical power unit is built exclusively for the massive lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived through the solenoid valve along with the velocity controlled by a stress compensated movement control valve.
Electrical power UNITS FOR LIFT TABLE four
Common Description
This energy unit is created exclusively for the large lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived by the solenoid valve and also the pace controlled by the adjustable needle valve. Once the lift rises to a higher positoin, but the electrical power provide is lower, the lowering motion is managed from the guide override perform.
Particular Notes
1. This power unit is of S3 duty cycle, which could only perform intermittently and repeatedly, i.e. one minute on and 9 minutes off.
2. Clean each of the hydraulic components concerned just before installation of the power unit.
three. Viscosity in the oil shoud be 15~46 cst,which must also be clean and totally free of impurities.N46 hydraulic oil is encouraged.
four. Oil changing is required just after the initial a hundred operation hours,afterwards as soon as each and every 3000 hrs.
5. The power unit shown is made to be mounted vertically.